• Windows 95/98/NT/2000/XP
• All features and relay types supplied as standard
• Fully Automatic or Manual Control
• Extensive results archiving, presentation and printing features as well as error/trend analysis
• Full on-line operating manual
• COMTRADE/DFR/EMTP replay
• Results are fully traceable to test set hardware, software and calibration data.

Voltage Outputs

• Three fully independent & floating outputs 
• 0-300Vac Range / 300VA Power
  <0.15% Error Typ., 0.25% Max.
  0.01V Resolution, <0.15% Distortion
• Single 0-900Vac o/p via series connection

Current Outputs (3-Ph Mode)

• Three fully independent & floating outputs 
• 0-35A Range / 300VA Power
  ±90V peak (63Vrms) Compliance Voltage
  <0.15% Error Typ., 0.25% Max.
  0.001A Resolution, <0.15% Distortion

Current Output (1-Ph Parallel Mode)

• 0-105A Range / 900VA Power
  ±90V peak (63Vrms) Compliance Voltage
  <0.3% Error Typ., 0.5% Max.
  0.001A Resolution, <0.3% Distortion

Current Outputs (3-Phase Series Mode)

• 0-5A Range / 900VA Power
  ±270V peak (191Vrms) Compliance Voltage
  <0.3% Error Typ., 0.5% Max.
  0.001A Resolution, <0.3% Distortion

Frequency

• DC to 4 kHz System bandwidth
  0.001 Hz Freq Resolution
  < ±10 ppm (< ± 0.001%) Error
• Mains Sync Feature: precise PLL freq & phase lock to input supply freq. (40-70Hz)

Phase Angle

• 0-360º Range
• 0.01º Resolution
• < ±0.1º Error

Contact Inputs

• 6x contact inputs, individually isolated
• Software selectable as wet/dry, contact/2.5-300V AC/DC voltage
• 10kHz sample rate (±0.1msec resolution)

Contact Outputs

• 6x contact outputs, individually isolated
• Rated 10A@300Vac or 1A@150Vdc
• 10kHz update rate (±0.1msec resolution)

Timer

• 0-99999.9999 sec Range
  < 10 ppm (0.001%) Error, ±0.1msec Resolution
• Synchronised to waveform generation

DC Supply Output

• 0-260Vdc, 200W Power
  <0.5% Error, Ripple <0.2% of range
  0.01V Resolution
• High startup-surge capability

Scope Input

• Two isolated input channels 
• ±10V, ±100V & ±500V ranges, 12-bit resolution, < 0.5% Error
• Synchronised to waveform generation
• Simultaneous recording of contact inputs
• Large acquisition memory permits recording time of up to 3.5sec at 10kHz.

 Miscellaneous

• Interface for comms to PC parallel port
• RS232 interface for relay comms
• Expansion Interface connector
• Software based calibration
• Comprehensive Overload, Thermal and Externally applied voltage protection on outputs

• Fully automatic universal input: 90-260V 45-65Hz AC
• 200W no load, 2400W continuous max
• Active Electronic Power Factor Correction (CosΦ>0.99)

• 0-50°C Operating Temperature
• 5-95% Relative humidity (non-condensing)
• IP20 Protected Enclosure
• CE Marked, Tested to EN50081-2 (emissions) & EN50082-2 (susceptibility)
• 380x210x400mm (not including handle)
• 17.5kg Weight